Here is a timelapse of my Inventables X-Carve 750x750mm build. The entire build was about 5 hours over the course of two days. Calibration and adjustment took about an hour. Initial software setup was easy and comprehensive. I used this X-Carve to cut circuit boards for the KFETS.
Sidebar[Skip]
Twitter Feed
Sign Up to Recieve Blog Updates!
Blog Archive
- April 2018
- March 2018
- February 2018
- January 2018
- December 2017
- November 2017
- June 2017
- March 2017
- February 2017
- January 2017
- December 2016
- November 2016
- October 2016
- September 2016
- August 2016
- July 2016
- June 2016
- May 2016
- April 2016
- March 2016
- February 2016
- January 2016
- December 2015
- November 2015
- October 2015
- August 2015
- July 2015
- June 2015
- May 2015
- April 2015
- March 2015
- February 2015
- January 2015
- November 2014
- October 2014
- September 2014
- August 2014
- July 2014
- June 2014
- May 2014
- April 2014
- March 2014
- February 2014
- January 2014
- December 2013
- November 2013
- October 2013
- September 2013
- August 2013
- July 2013
©veryhappyrobot.com All Rights Reserved
