My Blog
X-Carve Build Timelapse
Here is a timelapse of my Inventables X-Carve 750x750mm build. The entire build was about 5 hours over the course of two days. Calibration and adjustment took about an hour. Initial software setup was easy and comprehensive. I used this X-Carve to cut circuit boards for the KFETS.
KFETS Part 6: Circuit Boards 2
Now with the X-Carve in my toolbox, I was able to prototype circuit boards much more rapidly than the last method (etch resisting). This way, I was able to test and revise much more quickly, speeding up my process significantly. Below, I depict multiple different projects as examples.
There were three stages to making a board with the X-Carve:
1. Designing the PCB
Using easyeda.com and a similar design that I had prototyped earlier, I made a schematic and a PCB. Below is a timelapse of me designing on …
